How embossing roll is made out of

1. Cutting: body roll seamless steel pipe, 45 # round head with a shaft ends and flange

2. Turning: Turning roller body, end plates and the shaft member with the top part of the joint surface,

3. welding :( reference to the drawings, the inside of the roll if the oil-through or pass water and other structures need to advance in the pipe welding process)

Body roll pipe welding: correction ends of the shaft and the inner sleeve coaxial, only welding head shaft inner end plate.

The suit fit within the junction roller body, end plate welded inner roller body.

The outer end plate mounted at both ends of the shaft, the outer end plate welded to the shaft and the roller body joint surface junction.

4, blank roll annealing treatment to eliminate internal stress.

One end of the car flattened ends 5 ,. steel rollers, standard drilling center hole.

6 ,. Turning: sub-thick, steel finishing various parts of the roll body of drawings to size and then frame the center frame, facing, drilling to size.

7 ,. patterns according to customer requirements in the roller surface machining patterns. This is the embossing roll production process vital part requires embossing roller production staff have a wealth of experience, based on customer demand patterns to develop the production process. In the production process, stamping division to be serious, careful, meticulous, produced the pattern to be a clear pattern, rich layers, three-dimensional sense.

8, after the pattern is completed, the roll surface hard chrome plating layer or other coating materials (based on customer use embossing roll may be)

9, static balance correction steel roller